Federal Communication Commission Interference Statement

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one of the following measures:

-Reorient or relocate the receiving antenna.
-Increase the separation between the equipment and receiver.
-Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
-Consult the dealer or an experienced radio/TV technician for help.

FCC Caution: Any changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate this equipment. Only the shielded USB cable provided with the MR51FN may be used with this device.
This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter.

Important safety information regarding radio frequency (RF) exposure and use when worn

The product “MR51FN”is declared to conform with the essential requirements of the Federal Communications Commission of the U.S. Government.
This wireless portable device complies with the FCCrequirements for exposure to radio waves.
Your wireless portable device is a radio transceiver and receiver. It is designed not to exceed the SAR*(Specific Absorption Rate) limits** for exposure to radiofrequency (RF) energy by the FCCDirectives.
The Max. SAR* value is 1.41W/kg (1g) when it is worn on the body. To comply with the RF Exposure limits.
For body worn operation, this device has been tested and meets the FCC RF exposure guidelines.
Duringcommunication, please use an accessory designated for this product andwhich positions the device a minimum of 1.0cm from the body.
The use of accessories that do not satisfy these requirements may not comply with FCC RF exposurerequirements, and should be avoided.

* The exposure standard for wireless portable devices employs a unit ofmeasurement known as the Specific Absorption Rate, or SAR.
** The SAR limit recommended by theFCC is 1.6W/kg averaged over 1g of tissue.
*** Tests for SAR have been conducted using standard operating positions with the transmitting at its highest certified power level in all tested frequency bands. Although the SAR is determined at the highest certified power level, the actual SAR level of the wireless portable device while operating can be well below the maximum value. This is because the wireless portable device is designed to operate at multiple power levels so as to use only the power required to reach the network. In general, the closer you are to a base station antenna, the lower the power output.

Radiation Exposure Statement

The product comply with the FCC portable RF exposure limit set forth for an uncontrolled environment and are safe for intended operation as described in this manual. The further RF exposure reduction can be achieved if the product can be kept as far as possible from the user body or set the device to lower output power if such function is available.

FCC ID Location

The device is electronically labeled and the FCC ID can be displayed in the CertificationInformation.

Display procedure

Starting from Home Menu:
Step 1 –accessing submenu (“Information”)
Step 2 –access submenu (“Certification Information”) ,and regulatory information is displayed.